Control Panel Functions
Plug the machine in and pull the isolation switch out to power up the machine.
Power indicator light:
· Indicates that power is on.
Function indicator light:
· When in "Run Mode" light is on.
· When magnet is detected light will go out momentarily.
Detection mode indicator:
· Indicates which mode machine is in.
· "OFF" - No detection. Machine grinds sequentially.
· "AUTO" - Automatically detects double cutters (left or right).
· "MAGNET" - Corrects only after chain magnet passes proximity switch.
Stop / Reset:
· Stops the machine
Start:
· Starts the feed mechanism.
Grinder:
· Turns the grinder motor on - press again stops motor.
Speed Increase / Inch Fwd:
· Increases feed speed in run mode.
· "Inches" machine forward when not in run mode.
Speed Decrease / Inch Rev:
· Decreases feed speed in run mode.
· "Inches" machine in reverse when not in run mode.
Detection Mode:
· Changes between the three detection modes and is shown by the Mode Indicator lights.
Counter:
· Sets number of times chain circuits (maximum of 9)
· Counter is triggered by placing the magnet on chain (Low down on sideplate,on or between the rivets of a cutter).
Counter Display:
· Indicates number of circuits chain will do, referenced by the chain magnet.
Holding Counter + Speed Increase:
· Positions the machine for adjusting the top plate angle of LEFT hand cutters.
· Display will show a symbol.
Holding Counter + Speed Decrease:
· Positions the machine for adjusting the top plate angle of RIGHT hand cutters.
· Display will show a symbol.