LOWERING THE DEPTH GAUGES
1 Set the grinding head angle for "0" degrees as described earlier.
2 Replace or redress the grinding wheel so that the edge of the wheel suits the shape of the depth gauge.
3 Wind the depth adjusting screw in so that the grinding wheel is clear of the chain.
4 "INCH" the machine, adjusting the cutter position screw and the depth adjusting screw until the depth gauge is directly under, but not touching, the grinding wheel.
5 Select "OFF" mode
6 Press "START" then "GRINDER"
7 Adjust the depth adjusting screw for the amount of material to be removed.
* To reset the bevel angle refer to page 31.